Technical Specifications
SPL
112 dB
Amplifier Power
200 W Bass (Class D) + 150 W Treble (Class D)
Frequency Response
33 Hz - 22 kHz ("-6 dB")
Accuracy of Frequency Response
± 1.5 dB (38 Hz - 20 kHz)
Driver Dimensions
⌀ 205 mm Bass + ⌀ 25 mm Treble (view in inches)
Dimensions
H 452 x W 286 x D 278 mm, with Iso-Pod™ (view in inches)
Weight
12.8 kg / 28.2 lb
Connections
1 x XLR Analog Input
1 x XLR AES/EBU Input
1 x XLR AES/EBU Output
2 x RJ45 Control
8350A
SAM™ Studio Monitor
Technical Specifications
All the intelligence of Smart Active Monitoring in an extremely potent nearfield monitor. Introducing the Genelec 8350A.
System Specifications
Frequency Response
38 Hz - 20 kHz (± 1.5 dB)
Low cutoff -6dB
33 Hz
High cutoff -6dB
22 kHz
SPL
Peak SPL Maximum peak acoustic output per pair in a listening room with music material at 1 m.
≥121 dB
Short term max SPL Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz at 1 m.
≥112 dB
Long term max SPL Maximum long term RMS acoustic output in the same conditions with IEC weighted noise (limited by driver unit protection circuit) at 1 m.
≥103 dB
Self-generated noise
Self-generated noise Self generated noise level in free field on axis (A-weighted).
≤5 dB SPL
Weight
Weight12.8 kg (28.2 lb)
Dimensions
Height
433 mm
Height with Iso-Pod
452 mm
Width
286 mm
Depth
278 mm
Enclosure
Enclosure material
Die cast aluminium
Enclosure type
Reflex port
Drivers
Driver type
Cone
Diameter
205 mm
Driver type
Metal dome
Diameter
25 mm
Directivity
Harmonic distortion
> 100 Hz ≤0.5 %
Group delay
The latency at high frequencies from the input to the acoustic output, measured in the analog input:
Extended Phase Linearity in GLM set to OFF
3.0 ms
In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.
Amplifier Section
Amplifiers
200 W Class D
150 W Class D
Mains voltage
100-240 VAC 50/60Hz
Power consumption
ISS Active
≤1 W
Idle
≤12 W
Full output
230 W
Signal processing section
Connectors
Input Analog signal input connector XLR female, balanced 10 kOhm.
Input Digital signal input connector XLR female 110 Ohm.
Output Digital signal output / Thru connector XLR male 110 Ohm.
2 x Control Two CAT5 (RJ45) GLM Network connectors for computer control using the Genelec Loudspeaker Manager (GLM) software.